Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
We need a second thread on this?
I can answer any questions you may have. Its not too hard to setup.
I have configured vlans on the 28xx, 54xx, and 62xx series switches.
Use the cli for those switches for christ sakes.. it's not fucking hard
interface ethernet 1/e1
switchport mode access
switchport access vlan 10
or
switchport mode trunk
switch port trunk allowed vlan add 10
Don't know if these are 100% the same, but if you look at these screen shots the trunk ports have the PVID as blank. I also have a 3024 at home and whenever I create a trunk port I usually leave the PVID at 1 (I don't use VLAN 1 at home for anything).
As for the PVID it should get changed to whatever vlan your sending it to. If your doing it untagged. Usually you have to change them when you get into you trunks.
In your example your putting ports 21-22-23-24 as T (tagged Ports), if you do that and just click Save what happens (aka don't mess with the PVID). If it errors in what happens if you go into the PVID settings and for ports 21-22-23-24 and put in something like 1000, or another vlan your not going to use?
i have a 2724 feeding a pfsense interface with multiple vlans. the switch port wired to pfsense is 'T'agged on the VLAN Membship for each of the vlans to trunk to pfsense.
this is the tricky part that I was stuck on, under Port Settings, for the switch port wired to pfsense, i had to give it a PVID of 4095 (which is indicated as the 'ALL' id)