Dead motherboard?

Tiberius

[H]ard|Gawd
Joined
Nov 6, 2007
Messages
1,110
I went to turn on my PC last night and it was stuck on the memory count. I have a SAPPHIRE PI-AM2RS780G with the LED diagnostic code. It was stuck at 50 (which I believe is initializing the USB). I disconnected everything and it went through the startup but then I a blue screen before Windows started. Its been fine for months with no issues; I had to go so I just left it.

I came back later and turned it on and it booted fine. I installed a new video driver and when the PC rebooted, it because stuck again. This time the LED code was 52. I cleared the BIOS and was able to enter the setup. Odd thing was that the text was messed up. Everywhere that there was supposed to be a blank spot, there was a zero.

I disconnected everything and took out my GTX275 and put in an ATI X300 video card and it still gave me the same code. I took everything appart, reseated the memory and reconnected everything. When I start up, it gets stuck at LED code 75 or 7F. It alternates. One of those codes has to do with initializing the PATA/SATA system but it does it with no SATA drives connected (I just have one sata hd and one sata dvdrw on the PC).

So, is it dead Jim?
 
have you tried flashing the bios? i would flash it just incase it may have become corrupt.
 
unfortunately, I cant get it past initializing the SATA/PATA devices so I cant boot into it.
 
not sure how sapphire is in sending out bios chips, i know asus will.

the other option you have is to hot-flash the bios if you have another working pc with the same bios socket.. its not terribly hard but a lot of risk involved in bricking the bios.

and just to make sure , youve disconnected everything from the board including hdds, all expansion cards etc..?

have you reset the cmos using the jumper or pulling hte batter?

if you start it up without the memory and video card do you still get the same code on lcd?
 
I cleared the CMOS using the jumper. I've not tried it without ram or video....I'll try that when I get home tonight.
 
Well, not sure what or how it happened but.....

I took out the battery, I placed the jumper on the clear CMOS position, unplugged the power cord for a few minutes, turned it on with no battery and the jumper still in the clear position then I put the jumper back in normal operation and it booted back into the BIOS. I then started to add the video card back, the rest of the RAM, I reconnected the SATA drives and internal USB devices. It seems to be working.

Could the BIOS somehow get corrupted? I'm gonna do some stress tests to make sure I still don't have a hardware problem.
 
well....that wasn't it at all. Bad ram stick. I never had brand name memory go bad on me. I have 4 sticks of Crucial Ballistix.
 
Back
Top