Concern About Whether or Not PSU Will Fit

C

Cod

Gawd
Joined
Mar 21, 2003
Messages
642
Today I bought the SeaSonic M12II 620 Bronze 620W PSU. It is 6.3" in length. I bought the GD05 a few days ago and realized the max length of a modular PSU with the standard 120mm fan is 6.299". Is this going to be a problem? I can switch out the 120mm fan with an 80mm fan, but would like to keep the 120mm fan if possible.

So what I'm asking is, should I go ahead and pick up an 80mm fan? If not, will I need to do anything special when I install the PSU?

Any help is greatly appreciated.
 
There are thin-sized 120mm fans out there that you can buy instead of a 80mm fan. However try fitting the PSU and fan first and see if they will fit. If not, then buy this thin 120mm fan:
120mm Yate Loon D12SL-12C Case Fan - $5
 
After installation, I realized the specs given in the case manual must have been mis-typed because take a look:

DSC018051.jpg


The only issue I'm having is that the back of the PSU seems a little heavy for the four front screws. It sits noticeably lower, so I'm curious what I can put in their to make it sit straight and not restrict operations. I was thinking one of the little rubber spacers that can be used to separate a PSU from a HDD cage. Here is what it looks like currently:

DSC01806.jpg


Any thoughts are greatly appreciated.
 
That's fine as is: The PSU is drawing air from the bottom of that case through the bottom grills. So really nothing to worry about.
 
You must log in or register to reply here.
Back
Top