Brass + Copper

A

Apache0c

n00b
Joined
Feb 16, 2010
Messages
19
I know that Aluminum is a big no-no to mix with copper in your loop. But it is fine to use Brass, correct?

I ask because I have two brass fittings to adapt my Thermochill PA 120.3 to the G1/4 1/2" fittings.
 
yes, fine, nothing to worry about. Nickle which is used to plate a lot of stuff is fine too. There is a "table of galvanic interaction" table of metals on the net that lists all common metals and the farther apart on the list the more reactive (prone to promoting corrosion) they are and metals that are close to one another on the list are no problem.

hmm.
http://www.corrosion-doctors.org/Definitions/galvanic-series.htm
 
Super helpful Bill. I too needed info like this.
Thx and have a good day, eh. ^_^
 
You must log in or register to reply here.
Back
Top