Asus A8N-E boot problem (beep error code)

Misiowiec

n00b
Joined
Mar 4, 2007
Messages
7
I've been running XP on a Asus A8N-E motherboard for a good while without any problems. The other day I replaced my Hiper Type R 580W PSU with a Corsair HX 520W, and now the PC won't boot and beeps 1 long followed by 3 short. I've stripped it down to bare essentials (motherboard, VC, memory and CPU) but I get the same problem. The problem also persist when I reconnect the Hiper PSU.

According to www.sysopt.com/forum/showthread.php?s=&threadid=146656 these codes mean "memory test failure". I've tried:

1. Reseating everything.
2. Using any possible combination of memory stick(s) and slots (have 2 x G.Skill PC4000)
3. Clearing the CMOS.

I'd really appreciate any clever ideas!
 
heh according to this.
http://bioscentral.com/beepcodes/awardbeep.htm

its your video card /shrug

get on the horn with asus support.

But in the meantime reseat your video card again, just for grins. I can see it being not quite seated properly as a much more likely thing than the memory suddenly going bad.

Loosen the screw holding the vid card down or dont put it back on until after you try to boot. (lol make sure power is off, dont want to drop it onto the board when its live. ) Due to some cases not being made well, having a tight screw will sometimes tilt the card so some fingers dont make contact in the pci slot, look along the slot where it plugs in for even depth of contact. sometimes a couple of nylon washers under the vid card bracket will help "level" a card out but the damn things go everywhere next time you take it out.

sorry not terribly clever but these kinds of "wth did I do?" will drive ya nuts. Good Luck.
 
Thanks for the suggestions, and the other beep code list. It won't start no matter what I do, and I've played with the two PSUs, the memory and the video card to no end.

When I remove both the memory and the video card it beeps 1 long followed by 2 short, which also points to the video. Guess it's the card or the socken then. Will have to wait until my mate who has the same setup is back from his holiday, and then I can really test.

Such a pain though, it's really a "wth did I do?" situation that makes no sence!
 
Well, it was the motherboard - tested it and my stuff worked fine in a mates PC, while his gives the same error (beep) in my motherboard. Upgraded to C2D instead as per sig.
 
I built my Mom a computer with that motherboard and it hasn't caused a single problem at all.
I'm sorry you were having problems.
 
Back
Top