ASRock GM31-S problem

TeeJay

Gawd
Joined
Nov 16, 2008
Messages
564
Hi everyone...

Alright so I found it obvious that it's the motherboard, not any other components.

So I got this motherboard(ASRock GM31-S) from my cousin, so I thought about building a small backup PC.

Since I have a 9500 GT thrown in my room without use, I put it in, it was never used before, in it's box.

1GB OCZ RAM

SUPREMEFX II Sound Card

435W PSU

160 GB Hard drive

...Anyway, I came to install a new clean copy of XP, first try I got an error message, that some file couldn't be copied, I skipped. And until I reached the installation of Windows XP, I get a "Fatal Error" at minute 39, which is 2 minutes away from installing drivers(37). Anyway, I restarted the system, and continued on, but chose to repair the windows instead. Then I got an another message, the same one(Fatal Error). I tried again and again, sometimes it would work, but I get a blue screen, or some purple, yellow, and white bits on my screen and the system gets stuck, things never changed, so I took off the hard disk and put it on my main PC, installed Windows XP, everything went fine, after ONLY installing XP, I shut down the system, took the hard disk back to my back up PC, and system runs fine, until user is logged on, I get purple, yellow, and white bits around my screen and system freezes(Btw, I also tried removing the sound card, switching the RAM, removing the 9500 GT and using onboard VGA, everything's the same).

I tried every component on my backup PC on my main one, everything works 100%...But for some reason, they won't do that on my Backup PC...

So I went in BIOS, disabled OC'ing and such stuff, but things were still the same...

Does anyone know what could be causing all this?

Please help me out, I don't like seeing stuff not being used while sitting next to me.

EDIT: Forgot to mention this; Sometimes while installing devices(On windows XP installtion), it gave me an error message saying something like The software for the following hardware did not pass windows logo test: Battery(when I tried installing using the backup PC, not my main PC)

I'm not sure of the message, but it's something like that.

Thanks in advance ;D

~TeeJay
 
Hello again everyone, I got to a part where the PC will start, and work fine until a second before logging into the Administrator User, when it reaches that, it restarts itself, and keep doing that over and over again. Any ideas?

Thanks
 
Does your WinXP disc have SP2 on it? If not, you might need to slipstream SP2 onto your disc or else it won't install properly. Could fix your problems.
 
Does the memory pass memtest? You can grab that and burn the iso to a CD and boot from that to test your memory.
 
Back
Top