ArticSilver 5 application technique

L

lopexo

n00b
Joined
Jun 7, 2004
Messages
5
Well, being the hard headed person that I am, I applied some AS5 to my A64 3200+ and spreaded it all over the top core of the cpu and installed my XP-90. Then I decided to read the instructions and discovered that I only had to apply a small amount in the middle of the cpu and lay the heat sink on top of it without spreading. My question is, should I remove the AS5 that I have alreay applied and use it like its recommended, or should I leave it the way it is??

On a side note: I just got a silencer5 for my 6800GT and the temps were about 78C idle....I removed the silencer and noticed that only about 1/2 of the heatsink was actually touching the core...what can I do to fix this? add more AS5?

suggestions appreciated.

Thanks
 
I started another similar thread here, and the dot seems to be the way to go. I'd clean it and reapply... but I don't know how big of a temperature difference it'll make.
 
my preferred technique is to put a tiny glob on the middle of the core, then spead it to all edges with single edge razorblade (as thinly as poss.). i think if you just put a dot in the middle, then applied heatsink you would spread it in a circle...couldn't tell you if it makes a bit of difference, really, just my way of doing it :p
 
missed that other thread. :)

any suggestions regarding the bad contact on my gpu core?
 
well, I decided to redo my cpu and getting 39C on idle.

I also reseated my silencer on the 6800GT and getting about 55C idle compared to 78C before. Do these temps look fine to you guys?
 
You must log in or register to reply here.
Back
Top