mikecoscia
Limp Gawd
- Joined
- Jan 26, 2005
- Messages
- 436
Had an issue with my 4870x2. Worked fine in games but had strange power up problems. It would not wake from standby, had to reset CMOS. Also on a cold boot up the board would report no VGA. After a quick reset usually worked fine, sometimes it required a CMOS reset.
Picked up a cheap ATI 4350 and no issues with it. Standby worked fine, and no powering on problems. So I RMAed my 4870x2
Just recieved it and tested it out a few minutes ago, BSODs. Made sure I was in safe mode to install drivers, Cats did not recognize the card. Finally managed to get it installed out of safe mode, and on restart BSOD. So called visiontek and they are sending out another. Just hope I don't go through this more than once.
Anyone else have any dealing with visiontek's RMA process?
Picked up a cheap ATI 4350 and no issues with it. Standby worked fine, and no powering on problems. So I RMAed my 4870x2
Just recieved it and tested it out a few minutes ago, BSODs. Made sure I was in safe mode to install drivers, Cats did not recognize the card. Finally managed to get it installed out of safe mode, and on restart BSOD. So called visiontek and they are sending out another. Just hope I don't go through this more than once.
Anyone else have any dealing with visiontek's RMA process?