AHCI mode on IP35 Pro

Joined
Mar 1, 2008
Messages
59
I've got an IP35 Pro with a WD6400AAKS and both the JMicron and the Intel controllers are set to AHCI mode. I think all of the SATA devices are on the Intel controller. I just did a clean install and installed the Intel Chipset drivers. When I went to install the Intel Matrix Storage Manager my computer won't log in. It locks up at the login screen. I don't want to do RAID, I'm just trying to figure out how to enable NCQ for sure. I've done a ton of google searching and everything seems to be about switching from IDE to AHCI mode. I thought by installing the Intel software, I might be able to figure out where NCQ mode is. I've got Vista x64 BTW.

I previously had installed Vista in IDE mode and was able to switch it over to AHCI mode, but when I had this problem with the Intel RAID software, I thought that switch was part of the problem so I did a clean install with BIOS set to AHCI.

I don't understand why I can't find the option to enable NCQ. It seems like it's under Storage Controllers in Device Manager for nForce chipsets (from google searches), but I can't find it for the ICH9R. So my questions are:

1. Does anybody know why the Intel Matrix Storage Manager locks up my comp?
2. Where is the option for NCQ in Vista?
 
No odea why installing Intels MSM would lock up your rig, however I believe NCQ is a hardware level function and should function normally once AHCI mode is enabled. (someone correct me if I'm wrong please)
 
I think the bigger question is, do you really need it? NCQ has been worthless on a desktop, single user computer. I wouldn't even bother with it, to be honest.
 
Thanks for the replies so far. I guess I thought NCQ is better for the drive even if I don't see any performance gain from it, as far as being more efficient/less wear and tear. So is the general consensus that if my drive is running in AHCI mode that NCQ will be enabled?
 
I guess I thought NCQ is better for the drive even if I don't see any performance gain from it, as far as being more efficient/less wear and tear.
That's a new one I haven't heard. You're spending a lot of time and worry on a feature that makes no difference on a desktop computer. Don't hold me to this part, but I vaguely remember an article that showed NCQ decreased performance on a single user, desktop system. Honestly, there's no real performance difference between AHCI and IDE either.
 
If you install in AHCI mode using Vista it will load a generic AHCI driver. Once windows setup is done, go ahead and install the lastest chipset drivers which will contain the correct ICHXR or non R driver and replace the generic Vista driver. Re-boot and in the device manager you will see the Intel driver. After that NCQ is automatically enabled.
 
I vaguely remember an article that showed NCQ decreased performance on a single user, desktop system.
It did on my Nforce 4 chipset system.

You're spending a lot of time and worry on a feature that makes no difference on a desktop computer.
I'll second that emotion. ;)
 
Back
Top