A8N and memory

GlimmerMan

Gawd
Joined
Feb 13, 2005
Messages
982
I was running memtest86+. All memory settings in BIOS at "auto".
According to memtest, the memory is running at 216Mhz (DDR 432), CAS 2-3-3-5
I though this was a DDR400 system, is it not? I'm didn't do any overclocking.
 
GlimmerMan said:
I was running memtest86+. All memory settings in BIOS at "auto".
According to memtest, the memory is running at 216Mhz (DDR 432), CAS 2-3-3-5
I though this was a DDR400 system, is it not? I'm didn't do any overclocking.

What does your FSB setting say in BIOS? It sounds like your board is doing Auto-overclock of around 8%. Check the AI Auto-Overclock settings. Maybe AI Booster or something like that. I can't remember what it's called.
 
Thanks. Found it. Its "jumper free settings". It was set to "auto", which apparently means FSB=216.
I also found that by lowering the FSB a bit, I can get my Corsair XLs to run at the advertised 2-2-2-5 with no memtest errors yet. I'll play with this some more.
I'm a bit surprised the board overclocks the FSB by default. Wouldnt this cause a problem if someone was using marginal memory?
 
You could also give the RAM some more juice and get up to 2-2-2-5 @216 maybe. Yeah, it's kind of strange to get that big of an auto overclock. Usually it's only a couple mhz (I'm on a Neo4 SLI and it runs at 201 at 200 speeds. 216 is a lot. Most memory could probably handle that OC as long as the timings were set to Auto, but once you start playing with the timings then the marginal memory starts dying.
 
Back
Top