7800 Waterblock Help

[amish_p0rnst4r]

Ok so here's the deal....

I already have the following for my new build...

Build will use 1/2" Fittings/Tubing (7/16" Tubing Possibly)

D5 Pump
DD BIP 120.2 Radiator
DD Fillport
Apogee CPU Block
Panaflo 120mm Fans

So my problem is kinda this....

I'm looking for a waterblock for my XFX 7800 GT Vid card (I'd perfer one that cools ram the pads also mainly for astecically pleasing value) Otherwise I'll just be going with a Silverprop CycloneFusion HL...

Now from my research I find the -

Nv-78 from Danger Den that uses 1/2 barbs

The following state they use 3/8 or 1/4 fittings so would adapters be a waste of time on my loop with one of these

I mean if not how would you go about connecting them

Innovatek g70 -

http://www.frozencpu.com/ex-blc-179.html

Aquagra 7800

link is to the 6800 but same fittings

http://www.sharkacomputers.com/aqcoaqfx68r2.html

Koolance l06

http://www.frozencpu.com/ex-blc-147.html

 

[Top Nurse]

Well if you want to keep up the flow rates you could run both video card blocks in parallel.