Recent content by zepcs

I've found on my setup with the XT and 3 monitors, 2x 1080p 60hz and a 1440p 144hz runs about 90w, but if I drop the 144 to 120 it goes down to 30w. I believe it depends on what the blanking time the monitor reports and it seems most monitors don't send a "standard" rate, which causes the vram...

I got mine last week, haven't had more than a few hours to play with it, pretty impressive so far. Also I just saw this posted, looks like all q3 emails are out: https://www.gamingonlinux.com/2022/09/steam-deck-q3-invites-are-all-out-early-as-valve-beats-own-production-estimates-again/

Got my 512gb email today, order complete.

It took me 2 tries to get the screen done, make sure the DWIN_SET folder is the only thing on the sd card when you put it in the back of the screen.

I got a v2 as my first printer last month. Did the bltouch 3.1 from creality and couldn't get their firmware to work at all, 4.2.2 stock board and it would just beep at me when I tried to flash it. Ended up finding the smith3d firmware and guide and it works great...

I used the XT for quite a few years, lost it in a move. Picked up an Icemat and have been using it for well over 15 years now.

I finally said hell with it and ordered a whole pc, ended up getting what I wanted (5900x and 3080). Took 3 weeks from order to delivery, hate to pay for the privilege for someone else to put together my pc but my old 970 really wasn't happy at 1440p.

I too was tempted, but since I can't buy a gpu anyway I will keep waiting on the 5900x. I'm still rocking a 4790k and a gtx 970, without being able to buy a gpu it would just be a waste.

10+ In stock at microcenter here in MN.

So all our taxes are going down right? If you have to pay them to do their job, no reason they should get the tax money too.

Looks like adding it to the override fixed it. In the edit scsi_vhci.conf I added scsi-vhci-failover-override = "STEC ZeusRAM", "f_sym"; After a reboot I see 2 paths, and proper enclosure/slot information on the lsi sas2/3 controller. Additionally the disk only shows once in the...

I definitely want to use multipath, I want to use the ZeusRAM as a write-log for a pool. Do I select both copies of the disk when I add it to the pool? In testing I only selected one and my sync wire performance seemed to hit a wall around 100MB/s, which was quite a bit lower than I expected...

Not sure why but multi-path doesn't seem to be picking up my latest addition, it configured the rest of the sas drives on the same controllers and enclosure as the zeusram, but it is listed twice. Not sure how to edit the config for it to be recognized. c22t5000A72B3007B073d0 1 via dd...

The change I am most looking forward to is the clock being on all taskbars when you are running multiple monitors.

I'm quite happy with napp-it.