• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Recent content by TripleSeven

  1. T

    The FCC Has Unveiled Its Plan to Repeal Its Net Neutrality Rules

    Over here (Portugal) it's not quite like that. Our mobile data plans have a set amount of internet traffic allotted to them, say 5GB for example. That data plan allows you to visit every site you want, up to a limit of 5GB. What they are selling now, are add on data plans for specific set of...
  2. T

    HP w2408 Owner Opinions

    Hello, Got my HP w2408 a few months ago. Colour shifting is really the major problem with this one, caused by it's TN panel. It's not that bad if you sit right in front, and keep your viewing angle stable. Glossy is good for rich colors, but you have to be careful with location setup...
  3. T

    3 fans on 1 channel

    That's what i did. Of the 3 side panel fans, only one has the 3rd wire connected to the controller. I can control the speed of the 3 fans at the same time, but i can't start the computer with a speed below 1500rpms, or else one or two of the fans might fail to start.
  4. T

    3 fans on 1 channel

    Time for an update. My "project" is almost finished. I've only some minor adjustments to make: -Better sleeving. It was my first sleeving job. There is room for improvement. -Re-route some cables -Matching the two front fan brackets -Relocate one of the CCFLs -Replace FDD and IDE 30cm...
  5. T

    3 fans on 1 channel

    Hi, Thank you for your replies. I've set up the fans according to the 1st picture, but i have some problems. Sometimes i get a good reading on the rmps, but other times it goes crazy. I've been getting readings of 6000rpms (fans are rated at 2500rpm), and sometimes one of the fans has...
  6. T

    3 fans on 1 channel

    Hi, I'm planning on using an Aerocool Coolwatch to connect all my fans (3x80mm, 3x120mm). Each of the 120s will have its own channel. The Coolwatch has 4 channels, so that leaves me 1 channel to connect the three 80mm. Since they'll be gruped toghter on the side panel of a Aerocool...
  7. T

    My first mod - Questions

    Hi, I've recently started my first mod. At first, i just wanted to clean up the cable clutter inside my case, and improve airflow. I then opted for adding some UV led fans and CCFLs. Working Material: Case: Aerocool Masstige Silver (Aerocool) PSU: Levicom Xilence 500W (Xilence 500W)...
  8. T

    IBM data loss

    Hi, I have a 30GB IBM Deskstar IDE Hard drive, DTLA series. That drive has some bad sectors at the beginning of the disk, but otherwise has worked okay in my old computer, serving as a temporary storage area for some files. Lots of reads and writes during at least a couple of years without...
See more
Back
Top