Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
heat pipes, about 25cm from the speaker. but i rearrange speaker positon since that photo, now they are slightly away from corner and tilted. corners are bad positions any speaker.
I have to clean my desk and wires on the floor and rearange speakers positions and tilt them. Also my computer case is going to the left side of the table. Amplifier is going to another desk, you can see it to the left in first image.
Its Chieftec case with Barton 2600@2300mhz, Gainward 6800...
(BE) (unknown attribute) 58 35 45 42 Failed
first number 58 is CURRENT VALUE
35 is WORST and 45 TRESHOLD so if temp is below treshold its not ok and you should consider to cool down your disk.
as you can see your current value is ok but once your disk was overheating
last value 42...
Under the health tab there is a line highlighted in red which reads:
(BE) (unknown attribute) 58 35 45 42 Failed
Anyone know what this means?
Be is temperature and you have old firmware thet did not report it as temperature but as unknown attribute. I had 3 wd 2500ks and first was like...
Hi! I will buy philips 200w6 widescreen or dell 2005 display very soon. Philips is similar to dell 2005 (same screen), but its cheaper then dell. I have oportunity to check display before i buy it so here is my questions:
Can I spot backlight bleeding in daylight? Becouse in store its to much...
My first drive died after 2 weeks becouse of seek error. That drive also has UNKNOWN attribute.
Second drive has Airflow instead of unknown attribute.it also (1 out of 20) report SMART failure status at the program (Data Lifeguard Diagnostic for Windows) start. Then I click at detailed view...
Hi!
I have wd2500ks, new, and Data Lifeguard Diagnostic for Windows sometimes (1 out of 20) report SMART failure status at the program start. Then I click at detailed view and EVERYTHING is green (pass) at the secend window, and at the same time, at the first (main program) windows SMART...