Recent content by NerdyMammoth

Looking for anyone that has experience with the Gofanco HDMI over IP (device pictured below), and operating them through spanning VLAN's via 10GB managed switches. I am using 4 sets of these over TEG-7080ES (10GB network switches). Here is a link to the diagram of how these devices are...

Not sure if your asking me, but I'm going to assume you are. Not sure the exact temperature as I haven't had a need to measure it. All the equipment stays rather cool inside, as there is a strong AC case fan mounted inside the top of the case.

Now, all the devices are visible to each other, but the video wont transmit (damn). On top of that, network traffic seems really high on the main network (VLAN1). Would it be because of this recommendation? Lets say I put the main network in VLAN10, how would that communicate with the rest of...

Small, but potent little sucker this one is.

To be future proofed for the next 10-15 years, and if cost is a factor you will get your best bang for the buck out of CAT6/CAT6e (not sure what difference the e makes). I recently wired up a home with CAT6 throughout, put in a NAS with a 10G card, as well as 3x8port 10GB switches, and...

I have 0 experience with RS file manager, however on a PC I would imagine it would be shared the same way as sharing a folder - just if you want to share the entire drive, you may have to edit those sharing permissions closer to the top of your file tree hierarchy. With that being said, from a...

I realized the original vlan config i presented in the first pdf did not accurately match the existing situation. I've detailed PVID's and VLAN configuration per existing, as well as Shockey's recommended way. I really only need the transmitters and receivers to land on VLAN30 (the 2 red dashed...

Your response is appreciated. I believe I did try tagging both VLANs on those ports but I shall try again. By any chance have you ever used trendnet’s teg-7080es or similar? Also any need to touch trunking?

Also, I know the easy solution would be to put 10G-SW2 and 10G-SW3 into PVID30, however there are other switches connected that need to remain on VLAN1. (if that makes sense)

I have this issue where we have some HDMI over IP transmitters and receivers and are not communicating through various switches. Attached is a diagram of the layout and VLAN configs. If anyone has experience specifically with the trendnet TEG 7080ES, that would be superb, but any and all VLAN...