Tried making one in a bootable environment but had an issue with booting into anything but legacy. Not saying I've given up on trying to make one, but I was looking for other options as well.
It's not for me. I'm going to pick up this work with a company that basically contracts it out to people who are signed up in the area. It's kind of like über.
Second job to help pay the bills.
I'm looking for a decent repair tool for computer work that I'm planning to do on the side. I need it to run diagnostics and virus removals. I'd also like it to have a few side tools for generic repairs.
I've looked into:
PC doctor (But it doesn't have virus removal from what I've seen).
EasyRE...
You make some good pointers in your post and I have read about the prime95 issue as well.
At this point, what I'm going to do is ask Asus about my current motherboard (Maximus 7 Hero) and if it auto overclocks even on default settings. If they say no or yes, I'm going to change my CPU cooler...
Before I decide to RMA a Processor I'm going to try and see if it's the cooler or the motherboard. Like I stated in a previous reply, my CPU's volts seem to be higher than normal. It could be that I have a bad CPU, but I'd rather not jump to that and have to deal with RMA until I really know...
This concerns me. This is the level I want to be at and I'm really not sure why It's not reaching it. I'll see about installing the stock cooler sometime later to view the results.
Did you by chance need to change the voltage the motherboard had set for you or alter any other settings? I'm using...
I do not overclock and my system is set to default bios settings. I checked with CPUZ to see if my clock speed was going over the default numbers and everything seemed normal.
My fans are already loud enough as it is. I do not think that would be the main issue as I haven't put a cap on...
Corsair H100i Water Cooler
Intel Core i7 4790k
With this cooling setup I have idle temperatures of about 33 Celsius and 55-60 Celsius while gaming. Now, while these temps are decent, I had hoped for a little better. None the less my concern comes from when I performed a Prime 95 Torture...
So I Looked at my mounting base on the bottom of my mobo and I noticed that my plate was resting on those two screws you have circled. The screws are not very big though, hardly seem to cause any issues with the mounting plate besides a little distention. Could that be my culprit?