Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
I have a Cisco 2611 router. I also have a SonicWall device that I would like to be behind the Cisco. How would I give the SonicWall a public IP with the Cisco (Nothing should be filtered in Cisco?
The reason I ask is I have a T1 Connection being installed. The SonicWall does not have a...
Just get an access point.
http://www.linksys.com/servlet/Satellite?c=L_Product_C2&childpagename=US%2FLayout&cid=1126536803676&pagename=Linksys%2FCommon%2FVisitorWrapper
The issue seemed to be either one of two things. Either the DC did not have internet connectivity prior to the new install, or the gateway was set to itself on the DC.
Went client's to swap out a SonicWALL Pro 100 for a 2040. I had previously completely configured the unit a the office. I get out there, plug everything up, and everything seems to be going good. But there was a problem with the two DCs. I could not get out to the internet. I could ping local...
Will there ever be a time when you don't have to explain that "username" is an indicator to use your specific username (without quotes...heh)?
Not directing at OP, just an observation in general.
Sorry, I completely missed your router type in your post. I think what may be easiest is just get this:
http://www.dlink.com/products/?pid=333
The main reason is because to use an AP in bridge mode the device you are bridging must be in that mode as well. This would basically disable your...
What type of device is you main router? If its a LinkSys: just get a LinkSys access point, enable bridge mode (Look in the manual), come out of the AP into a switch, plug in your other machines to the switch. This should get all you devices on the network. Make sure you check the documentation...
I have had no issues with my WAP54G. I believe it had Sveasoft firmware on it which helped increase range some.
An access point is basically just turning your wired connection into a wireless one. Just give it an IP on your wired network, configure your security settings, and you will be...
SonicWALL has their Network Anti-Virus/Spyware and Gateway Anti-Virus Spyware. I only run the gateway solution. You then don't have a client piece of software o the machine. But both would be ideal. The sonicwall also alows you to enforce the anti-virus on all machines behind it in order to...