Recent content by ghstintheshell

I originally bought this game for the PS3 but the graphics were so bad that I took it back to the store. I had been out of the console gaming scene for many years and I thought maybe the console versions of these games had finally caught up. I was so wrong but I am planning on picking up this...

....very true, good point...

29 views and not one comment? I am shocked....

I will be rebuilding my loop using all copper and acrilyic parts, my question is this....has anyone had success using an algaecide purchased for fish tanks?

ahhh, okay, good luck man. The primochill dye bombs work great, two of those with a little bit of the purple will give you blood red

i hope your not implying that i was talking about red tubing....

you should look in the case gallery thread. Just posted pics of my setup and im running a blood red coolant. I decided to go with Primochill Ice+ two blood red dye bombs. The primochill has a thick consistency than water had it adds a nice effect in the mini res

Im running Primochill ICE with Blood red dyd bomb, works well, like it allot

Unfortunately that fourth pin of the PWM pin cannot carry a fan speed signal so you have to have a seperate signal just for RPM, hence the four wires. If the PWM line could carry a fan speed signal it would only be a three pin. HOWEVER, PWM is far supperior to rehobus/pot controllers

The only way to know if the pot is bad is to hook it up to a voltmeter, measure the pot at both ends. First question is, will the motherboard increase power to the fan under load? Enough with my ramblings, i would simplly say that if you want full control, put it on a fan controller (20W per...

In response to the OP, the best wire to use would be a small gauge wire(20-24). Solder the ends, bend back the ends and put shrink tubing on them. You could also use small double open ended conectors, however these will result in a large growth in your wiring. So your best bet is solder and...

if your going to take the black louvre(shroud) off, i recomend stripping the case down to the chasis and powdercoating or painting the top black or it really will look horrible.

I just recenly got rid of my Cosmos. I had an MCR320 mounted at the top. The black shroud causes horrible temps, you have to cut the hell out of the top. Mount any rad on the outside

I have my MCR-320 mounted in the top of my cosmos 1000, i currently have air being pulled into the rad, through the top of the case. Should i be pulling air into the case or should i be pushing the air out through the top?temps are kind crappy, but that because i have the rad mounted inside me...