Recent content by a573573

Very nice drawing, I have a few ibuypower laptops! Thanks for letting us all attempt a win here!

Payment sent! Thanks

PM'd Back

PM Sent

You are wrong, On both comments there actually. Let's clear some things up a little. The CMOS will not be cleared fully unless or until you load and apply optimized defaults, and the Profiles saved will only be deleted if you clear the DMI Data (Disable Keep DMI Data). Deleting the DMI Data...

Reply here for you >> http://forums.tweaktown.com/f69/q-flash-raid1-dumb-question-31035/

I was just like to post about my experience with this Ultra Regarding this matter. This is for all the users who may doubt Ultra as a great company, their warranty, or for those who may be unsure of how easy this process would be handled. Sure mistakes were made somewhere with the making...

So did you ever look closely at your pins? I know you may not want to tear your case apart, but this is often the cause. You need to remember the memory controller is in the CPU. I have seen Many threads where this issue was caused by a bent pin

Sounds to me like you just need to redownload the file is all. Here I rehosted it for you, extracts just fine. So if you have issues again, re-download it a few times until you do not >> http://www.MegaShare.com/566121 http://www.mediafire.com/?gkdf3gxwfeg

Can you get into the BIOS with only one stick of ram? Try all slots, you should then try clearing your CMOS after that if you have no luck and then try again. See here for my method of clearing the CMOS, of course there are many views on how to get that done. This is just my method for...

You can get a case speaker here, plenty of links. (Also on Ebay) >>> http://www.google.com/products?q=motherboard+case+speaker&btnG=Search+Products&hl=en&show=dd&scoring=p Yes, If you do have any board flexing if you fix it now it wont stay that way. But if you leave it flexed for a long...

Sounds to me like your heatsink is casuing your board to flex, you need a Backplate! That flex is causing your mosfets to not properly touch the heatsink therefore they will not be cooled and can burn up very quickly Get ya one of these, not sure what Heatsink you have but you need a...

Well, I do think you should use the springs, just maybe some different ones or just dont make them so tight is all. Hey, I am glad you found it for sure! Sorry for not thinking of taking it out of the case, I generally only think of that after a few more replies in helping of someone...

I use that same backplate with my block, just dont tighten the springs so tight maybe. I do use my own screws and springs though. But I also did not remove the sticker over the sticky part, left it there, and added electric tape to the Whole back side just to be on the safe side Nice to...

Well likely not, the power button is a momentary switch. Jumper is the easier way of accomplishing the battery removal method, that is why it is there. I have a Switch on mine ON or OFF only type rocker, so off is always off and on/connected is always on if it is in that setting.