What temps should I be aiming for?

TheResidentEvil

[H]ard|Gawd
Joined
Jun 12, 2009
Messages
1,943
Looking to start OC'ing my QX9770. Right now at stock it idles at 35C and under load hits 60C. Is there no room for overclock on this? I am using a dark knight and this chip is supposed to be water cooled. Is 70C under load OK or is that too hot? 65C maybe? Any help is appreciated. Also I have a MSI board with Dual Core Center and it for some reason says my CPU is only 18 but the BIOS says 35. WTF?

The 35C and 60C I get from SpeedFan looking at the 4 individual cores
 
Last edited:
Anything under about 85C (+/-) a couple deg as that is where the CPU will begin to throttle and send out an "I am getting hot" signal to the motherboard to spin the fans to 100%, above 85C, we don't know how much but a good guess would be 10-20C at least, the CPU will shutdown.

Forget vendor software and bios for CPU temp, use Realtemp or Coretemp, or at least download and run and see if the vendor software agrees. Those programs use the embedded on die Digital Temp Sensors (DTS) and are the most accurate measure of CPU temp we have. Speedfan should be reading the DTS but check if the Tjmax is set correctly to 85C.

Your CPU is an exception (lower) to rules with a lower TjMax. It is critical any application reading the DTS has TjMax set properly in the software. TjMax -1 is within Intel's warranty "envelope" for 24x7 operation but obviously is pushing it. Most of us here like to see full load temps 15C below TjMax but it is up to you. Adding Vcore voltage when OCing is another reason one would not want to run right at TjMax.

I have tons of technical posts on this and a text search for TjMax should turn up a ton of them.

To directly answer your questions, Looks like you only have about 15C to play with if you maintain a 10C "cushion" (85-10= 75 and currently at 60)

80C is pushing it - not recommended (Hot day might cause throttling)
75C is running it hard - but OK if case airflow is very good and your normal applications should not be stressing the machine this much.
70C is fine
65C is fine

Again I stress make sure TjMax is set properly on whatever software you use as your CPU is rated 85C most others are 100C and it would be easy for the software not to catch it and give readings off by 15C.

Edit: burebista advice is exactly correct, just a bit conservative and since your CPU has a lower TjMax than most I provided more performance orientated numbers, Many times I too have recommended TjMax -20 as a good stopping point especially if one does not upgrade hardware often and you are looking to get 5 years out of the CPU + board .
 
quick question for you, bill.

is there any way to be sure that coretemp and realtemp are using the correct TjMax for my cpu? i've got a xeon x3440. the latest version of realtemp correctly recognizes it, however coretemp thinks it's an i7.
 
quick question for you, bill.

is there any way to be sure that coretemp and realtemp are using the correct TjMax for my cpu? i've got a xeon x3440. the latest version of realtemp correctly recognizes it, however coretemp thinks it's an i7.
You can check to see which Tjmax value the programs are using. Core Temp displays it in the main window, and Real Temp shows it in the Settings dialog box. The correct Tjmax for your CPU is 85C.
 
where did you find that number, though, zero82z? the 85C, i mean. is it on an intel spec sheet somewhere? 85C seems very low for a lynnfield chip. aren't the i5 and i7 higher, around 99C?
 
where did you find that number, though, zero82z? the 85C, i mean. is it on an intel spec sheet somewhere? 85C seems very low for a lynnfield chip. aren't the i5 and i7 higher, around 99C?
Sorry about that, I mistook you for the OP. The correct Tjmax value for your CPU is 100C. 85C is for the OP's QX9770.
 
oh okay, that sounds better. i'll have to double check when i get home tomorrow, but i think realtemp was using a tjmax of 99C by default. realtemp correctly recognizes my xeon, whereas coretemp thinks it's an i7, so i tend to trust realtemp a bit more.

either way, my temps are good. i'm around 62C after 20 runs through IBT on max stress, plenty of distance to tjmax leftover. :)
 
Intel finally spilt the beans at the 2009 Developers Conference in San Fran . The complete presentation used to be on Intels site but here is a summary of the temps.

http://www.anandtech.com/weblog/showpost.aspx?i=478

Pain to get the whole thing as for some reason it is not available anymore from Intel.
If you do a google on " TMTS001" rapidshare has a copy (PDF) and you will find some posts about it. I grabbed it from Intel when it was available but have no easy way to share it and I am sure its copywrited by Intel in any event.

(TMTS001 is the session ID, no clue why it is now gone)
 
Last edited:
Im a little confused...so i have realtemp running and it says my cores were idling at 50c, but i saw that TJmax was 85 for core2duo's.

So i went to settings in realtemp and put 85 for both cores TJmax.
Now it says 37 c for both cores..which one is right?
 
nevermind...i saw it was supposed to be TJmax of 100, so it was right before i touched anything
 
Im a little confused...so i have realtemp running and it says my cores were idling at 50c, but i saw that TJmax was 85 for core2duo's.

So i went to settings in realtemp and put 85 for both cores TJmax.
Now it says 37 c for both cores..which one is right?
It depends on the chip, but most newer Intel chips are 100C, including yours.
 
Back
Top