Anybody tried indium foil?

cptbjorn

n00b
Joined
Mar 30, 2009
Messages
8
I'm just getting into folding and now for the first time since my 2500+ Barton I feel the need to get my processor overclocked as high as possible. I have 5 feet or so of .003" x 1" high purity indium foil from other projects to play with but my initial tests on my E8500 are far from impressive. On the barton core, since there was no IHS and the core was quite small, it wasn't very difficult to get a high enough PSI on the interface for it to beat a proper application of normal thermal compound.

For the LGA775 on the other hand, the contact area of the IHS is 28x28mm, and from an Intel spec sheet I found a maximum recommended mounting force of 311 newtons. Some quick math and that only gives ~57.5 psi, which is about 1/3 of what I would ideally want. Has anybody experimented with (much) higher mounting forces? Is the 311 newtons the limit before cracking the die, or the limit due to the 4-hole WTF were they thinking motherboard mount? Can I exceed the limit if I properly reinforce the back of the motherboard?

Also indium has a melting point of around 155C, anybody know what will happen if I heat up the heat sink to 160C with it mounted to the (unplugged) CPU/motherboard? It would only be for a little while :D
 
Try this. I don't know how big that die looks, but it's seems to be about 1/4 of the area of the IHS.
 
Try this. I don't know how big that die looks, but it's seems to be about 1/4 of the area of the IHS.

Pretty sure the IHS on the Intel chips are soldered on.

And wile this does peak my interest, i think you would have better luck just buying some Coollaboratory Liquid Pro.
 
Some of the Core2 series IHSes are soldered on... some are just glued around the edges. I think the E7xxx series are glued, while the E8xxx series and the quads are soldered. Going farther back, it's not quite as cut and dry. Don't go by any of this info, either; I'm just working off the top of my head, from other threads I've read. I know some are soldered and some aren't though. That much I'm sure of.

Also, I know that once you remove the IHS you have to remove the top of the retention mechanism as well, since the heatsink otherwise won't make contact with the core. A guy sold a couple of de-lidded Core2s over in FS/FT a while back.
 
Also, I know that once you remove the IHS you have to remove the top of the retention mechanism as well, since the heatsink otherwise won't make contact with the core. A guy sold a couple of de-lidded Core2s over in FS/FT a while back.

Or just get your heatsink lathed down so it has a smaller contact area that will fit inside the dimentions of the retention mechanism. You know, if you're already going crazy, why not go COMPLETELY crazy? ;)
 
Or just get your heatsink lathed down so it has a smaller contact area that will fit inside the dimentions of the retention mechanism. You know, if you're already going crazy, why not go COMPLETELY crazy? ;)

Whole lot easier to just take the little retention "lid" off. You can even put it back on later if you want. Un-lathing copper is a lot more difficult. ;)
 
Back
Top