I purchased a PC4-1025BK last week, and I'm running my tubing to my different water blocks.
I noticed that I may have made another mis-steak.
It looks like my D-Tek Fuzion has 1/2" hose barbs, and the Koolance system is using 3/8" tubing.
Can I use some 3/8" hose barbs that came with my no-longer-needed Swiftec reservoir on the D-Tek Fuzion CPU block?
Or, can I stretch the 3/8" tubing to fit on the 1/2" barbs without causing other problems?
I can put 3/8" barbs on my GPU blocks (or, use 1/4" barbs and run the GPU blocks in parallel with the Koolance converters).
IH8Spam
I noticed that I may have made another mis-steak.
It looks like my D-Tek Fuzion has 1/2" hose barbs, and the Koolance system is using 3/8" tubing.
Can I use some 3/8" hose barbs that came with my no-longer-needed Swiftec reservoir on the D-Tek Fuzion CPU block?
Or, can I stretch the 3/8" tubing to fit on the 1/2" barbs without causing other problems?
I can put 3/8" barbs on my GPU blocks (or, use 1/4" barbs and run the GPU blocks in parallel with the Koolance converters).
IH8Spam