Arcygenical
Fully [H]
- Joined
- Jun 10, 2005
- Messages
- 25,066
Due to the recent interest in the phenomena of Galvanic Corrosion, I've decided to set up a test...
Three different glasses, filled with 450ml of tap water and various additives. I decided to use tap water rather than distilled + salt to accomplish 2 things:
The three groups:
In each glass there is a cleaned penny (5 minute soak in 25% HCL followed by a bath in 99.9% iso. alcohol and left to air dry) and a 2" long section of anodized aluminum L bracketing. The edge of each piece of L bracketing was then SEALED with a silicone sealant, as this is not an anodized surface:
The anodized sides, however, were left barren, in direct contact with the water. All sides were free of scratches when entering the solution, and were exposed to a 5% concentration of HCL for cleaning. The alligator leads are not touching the solution. The temperature of the solutions should remain at exactly 27c (as per my growing room) in a completely dark condition. The relative humidity (that shouldn't matter, given the glasses are sealed with plastic wrap) remains around 60% at all times.
(from left to right: Water with ground, Water with no ground, Water with Pentosin and ground)
I'll be updating this post when I come back to school... next September. I'll post pics of the anodes/cathodes through the sides of the glasses whenever I get to my apartment this summer, but we'll see how this turns out.
Should be interesting
Three different glasses, filled with 450ml of tap water and various additives. I decided to use tap water rather than distilled + salt to accomplish 2 things:
- Greater Conductivity
- No chance of salt corrosion on the Aluminum
The three groups:
- 450ml tap water + 40ml Pentosin G11 with common ground
- 450ml Tap water with common ground
- 450ml Tap water with no electrical ground
In each glass there is a cleaned penny (5 minute soak in 25% HCL followed by a bath in 99.9% iso. alcohol and left to air dry) and a 2" long section of anodized aluminum L bracketing. The edge of each piece of L bracketing was then SEALED with a silicone sealant, as this is not an anodized surface:
The anodized sides, however, were left barren, in direct contact with the water. All sides were free of scratches when entering the solution, and were exposed to a 5% concentration of HCL for cleaning. The alligator leads are not touching the solution. The temperature of the solutions should remain at exactly 27c (as per my growing room) in a completely dark condition. The relative humidity (that shouldn't matter, given the glasses are sealed with plastic wrap) remains around 60% at all times.
(from left to right: Water with ground, Water with no ground, Water with Pentosin and ground)
I'll be updating this post when I come back to school... next September. I'll post pics of the anodes/cathodes through the sides of the glasses whenever I get to my apartment this summer, but we'll see how this turns out.
Should be interesting