XP Pro SP2/Vista Beta2 dual-boot

Fleabus

n00b
Joined
Sep 4, 2005
Messages
57
Hi:

I Use WinXP Pro SP2 with 2 x 500GB Seagate Barracuda 7200.9 SATA 3Gb/s 7200RPM 16MB buffer HDDs in a non-RAID config.

I have a third identical drive which is new and unused that I’d like to add and use to dual-boot Vista Beta2.

I do not want Vista to interfere in any way with my XP Pro SP2 O/S.

How do I go about doing this?

Is there a good step-by-step page you can refer me to?

I’m assuming that I connect the new HDD, boot to BIOS Setup, enable the SATA port [3], load the Vista disc, Save & Exit.
I assume also that like with XP, I point the O/S installer to the new HDD, partition and format a Primary say V:,
say ok to install Vista there and partition/format the rest of the HDD later within Vista.

N.B. My main system is networked to two other boxes via a wired router. An MCE2005 box and another with XP SP2 Home.
They have printer sharing and all three have file sharing enabled. No password logins. I’m the only one with access to any of the thre boxes.
Any issues to look out for when Vista discovers the network?

Thanks,
 
You are right about how to install Vista, by pointing it to the third, unused drive. This will leave your XP files intact, however be away, it will change some of the boot files in XP to give you the choice of Vista or XP on boot. There is no real way around this, but it's pretty easy to undo.

Assuming Vista has drivers available for the printers, you shouldn't have any problems.
 
Back
Top