Long time reader, first time poster.
I've been running a Barton 2500+ (pre-40) for over a year now. Its proven to be a complete overclocking dud. It only reaches 2800 speeds before crapping out in Prime95.
This is my setup:
Asus A7N8X
2 x 512 Corsair XMS 2700 LL
Radeon 9800Pro AIW
2x Radeon 9200 PCI
2x WD 120g Specials
I'm interested in popping the Barton/NF2 out and putting in an A64 (probably a newcastle 3000+) and NF3. That should hold me over for another year or so.
A couple questions --
1) Can the Corsair LL generally handle DDR/400 speeds? I'd prefer to run these modules at loose timings, but would buy new RAM if it was a must. I've seen some sites which claim that XMS LL causes problems when running at CAS 3. Confirmation or denial would be wonderful.
2) Recommended motherboards? Im considering the Chaintech VNF3-250. NForce3 is a must b/c I love the unified drivers. Cant beat swapping processor and motherboard without even needing to install new drivers in Windows.
Posting this in both the memory and motherboard forums because I'm a n00b and a tool
I've been running a Barton 2500+ (pre-40) for over a year now. Its proven to be a complete overclocking dud. It only reaches 2800 speeds before crapping out in Prime95.
This is my setup:
Asus A7N8X
2 x 512 Corsair XMS 2700 LL
Radeon 9800Pro AIW
2x Radeon 9200 PCI
2x WD 120g Specials
I'm interested in popping the Barton/NF2 out and putting in an A64 (probably a newcastle 3000+) and NF3. That should hold me over for another year or so.
A couple questions --
1) Can the Corsair LL generally handle DDR/400 speeds? I'd prefer to run these modules at loose timings, but would buy new RAM if it was a must. I've seen some sites which claim that XMS LL causes problems when running at CAS 3. Confirmation or denial would be wonderful.
2) Recommended motherboards? Im considering the Chaintech VNF3-250. NForce3 is a must b/c I love the unified drivers. Cant beat swapping processor and motherboard without even needing to install new drivers in Windows.
Posting this in both the memory and motherboard forums because I'm a n00b and a tool