X800GTO:back from the dead!

commodore

Limp Gawd
Joined
Dec 29, 2002
Messages
297
My X800GTO AGP died on me a month ago and apart from causing a lot of frustration relegated me to onboard graphics... YUCK!

2 days ago when i came across this article ..

http://www.techarp.com/showarticle.aspx?artno=399&pgno=0

on graphics card repair and thought maybe id give it a shot. First i tried putting the card back in and hoped for some luck. Nope ...card was dead as a goose on thanksgiving.

So i take my card and sit it front of me to unsolder the old capacitors. I twisted the first one and thought maybe id give it one last try before the decapitation..just for old times sake. I popped the card in and switched on my rig. And the damn thing posted!!! I was too friggin shocked for words..i couldnt believe i was looking at my desktop a few seconds later.

NOW, someone please tell me what i did right?? ..or was it dumb luck?? All i did was maybe bend a capacitor a bit...thats it!
 
Hate to be the one to say it, but chances are your 'fix' is going to prove temporary. Still, best of luck, and no idea what you did, right or wrong.
 
At least if it breaks again you know which capacitor to fix. :p
 
One thing is certain that the fix is temporary. I'll get round to replacing that capacitor if at all it conks off again.

Its just that i never came across this happening to anyone.. 'fix' or whatever you like to call it
 
if you twisted the cap so that both leads are touching, you are effectively just bypassing the cap, which allows for more voltage swing across the components close in the power grid, lowering their stability and or lifespan

this IS assuming it is a power regulation cap though, but then again, what else would a cap do on a vid card?

id suggest replacing it ASAP, but congrats on resurrecting the card
 
I'm pretty sure the cap would have snapped off before it's legs touched.
 
It's possible the cap had a cold solder joint (i.e., a crack had developed and left a physical gap in the solder) and that twisting it closed the gap and made good electrical contact again by putting pressure on it in the right place. Such a fix could last a while. If you have a solder gun, a more permanent fix would be to heat the solder around the cap leads so that any cracks are melted together.
 
Back
Top