I did a search but can't find the exactly problems that I am experiencing.
I got a x800 xt pe from ebay, long story short. The seller RMA it to ATI and now I got a brand new card. Installed it with the latest CATALYST dled from ATI last night. Everything is in default setting, not OCed and the Overdrive is not checked. However, the problem is that some times my screen just goes black, like loosing signal from video for about 1 second and it turns back to normal again. This happens both in games and just on regular desktops. Anyone experienced this before or has a possible explaination as what might have caused this?
The power connector to video card is shared using an extantion connector with harddrive.
Power supply is Seasonic s12, brand new as well (power outout in each rail appears to be normal). Video card is connected to the dell 2405fpw through DVI. In bios, the agp voltage was set to 1.6v. I have turned off the AGP fast write and lowered agp volt to 1.5v, so far I haven't seem the problem come up yet but it was only used for about 15 minutes. I'll try again later today see what happens. In the mean time please share some of your thoughts.
btw, anyone can point me a good site for some optimal configuration on the CATALYST? This is my first ATI card, I've been using nvidia for years.
I got a x800 xt pe from ebay, long story short. The seller RMA it to ATI and now I got a brand new card. Installed it with the latest CATALYST dled from ATI last night. Everything is in default setting, not OCed and the Overdrive is not checked. However, the problem is that some times my screen just goes black, like loosing signal from video for about 1 second and it turns back to normal again. This happens both in games and just on regular desktops. Anyone experienced this before or has a possible explaination as what might have caused this?
The power connector to video card is shared using an extantion connector with harddrive.
Power supply is Seasonic s12, brand new as well (power outout in each rail appears to be normal). Video card is connected to the dell 2405fpw through DVI. In bios, the agp voltage was set to 1.6v. I have turned off the AGP fast write and lowered agp volt to 1.5v, so far I haven't seem the problem come up yet but it was only used for about 15 minutes. I'll try again later today see what happens. In the mean time please share some of your thoughts.
btw, anyone can point me a good site for some optimal configuration on the CATALYST? This is my first ATI card, I've been using nvidia for years.