Wireless Router: Get and Send Signal

alkaline

Gawd
Joined
Jan 31, 2006
Messages
727
My grandparents have a wireless network in their house. They use a WRT54GS on the ground floor to transmit signal. However, when they are in the basement, the signal is very poor. They went out and bought another WRT54GS router and figured they could use it to boost the signal. Of course, they have no idea how to do it, so I'm here to ask the following:

Can the 2nd router be configured to receive the wireless connection from the upstairs and then re-transmit? If so, is there a good guide on how to do this?
 
Yes, you can set your second router to be a bridge. I believe all you have to do, is change it from "Router Mode" to "Bridge Mode" and it'll do everything else by itself.
 
im guessing if their in the basement you could just drill a hole through the floor and run a cable to the second router below and use it as an AP. but depending on how poor the signal is down there using the bridge option shadow posted will work as well. but its only going to make them think they have a better signal then they really do. best option would be to make the basement router the primary then put the second one upstairs and have that as the bridge/AP router.
 
I just assumed his modem was connected on the first floor, but yes if the modem is in the basement, connect the router in the basement and use that as a primary, then the one upstairs as your bridge.
 
Back
Top