Windows XP Install Troubleshooting

kelcec

n00b
Joined
Jan 17, 2007
Messages
5
Hello everyone. I am looking for some troubleshooting advice.

Problem – Cant get Windows Installation to recognize my hard drives – then results in a Blue Screen (but BIOS recognizes HD’s)

Story:
I had wiped my hard drives and decided to install Vista. All was well for awhile, until I got fed up with non-compatible software. So I decided I was going to revert back to XP. I put in the XP disc and when it got to the screen that asks me to Create/Delete a partition it didn’t recognize my HD’s and when I pressed enter it gave me the Blue Screen.

Error:
Stop: 0x0000008e (0xC0000005, 0xF7418C13, 0xF6FD67E4, 0x00000000
setupdd.sys - Address F7418C13 base at F73ECC000, Datestamp 411107c8f

I did some research on this error and most people said it was due to faulty hardware, more specifically RAM. So I took out the RAM, switched slots, etc… no change.

I then decided to troubleshoot. I ran many utility programs to make sure the HD’s were clean. Ontrack/Derek’s Boot and Nuke, the works. Hard Drives checked out fine. I even went to the store and bought a new HD, and the same problem occurred.

I then decided to flash the BIOS. No change.

I read somewhere that maybe the MBR got screwed up from Vista. I booted into the recovery console and when I Typed in fixmbr or any of the other commands, didn’t work.

I’m really at a loss. If there is anyone that has some advice, Id love to try it out. I won’t be home until this evening, but thought Id see what everyone had to say. Thanks!
 
have you tried things like partition magic to try adn re-create your partiitons before you install?
 
Yes I have... I think it is hardware related. Any suggestions on what to do?
 
When you said you had swapped memory to different slots, did you also try some other memory? I would guess it is an issue with faulty ram which moving bad ram to another slot really wont help. Second thing would likely be the hard drive itself. Did you try and install on a different drive?
 
Are you using a service pack 2 windows XP cd or an original?

Since installing SP2; any time I've tried the recovery console when booting off a non sp2 xp cd everything just screws up.

Also, make sure you press F6 at the beginning of the XP setup to install any sata drivers that you may need. I'm not sure if that's just for RAID but it can't hurt to try.
 
I have 2 1gb Ram... I swapped them out. Do I need to buy a test RAM from best by or something?
 
(sorry just a noob trying to gather trouble shooting info)

Just wondering, may I ask, when you're installing drivers without the windows platform on the system, do you just pop the driver disc in and boot from the CD to install them?
 
Back
Top