Windows not loading?

rivacom

Limp Gawd
Joined
Jan 23, 2007
Messages
348
Some of you may remeber my post about a dead board not too long ago. Well newegg sent me a new one and this one worked! except I turn it on and it just goes in a circle. It boots, finds the memory and processor, goes though the bios and hits the windows did not start correctly thing. If i continue normally or any other option it ends up restarting and goes though the whole process again. I have tried loading something off the cd it came with but it doesn't seem to do much but contain more problems. I've been though bios and everything seems to check out, it detects both hard drives and niether seem to load(one has vista(ide), other has xp(sata). It is a K8 Triton Gigabyte GA-K8NE board and im out of ideas. any help would be great.
 
no, although it seemed kinda odd that changing the motherboard would cause two versions of windows, on two different harddrives to both break. I'll give it a try though.
 
Seen something similar before, but it is a longshot. Do you have any USB devices plugged in? Yes mouse and keyboard count. Try using PS2 mousekeyboard if you have them. If this fixes it, go into the bios and change the USB legacy support setting.

I don't know why, but there is a bug in some bios with USB legacy support. I've seen it on premades from all the manufacturers and I've seen it on a few system I have built.

Hope this helps, but it is a longshot.
 
No go on the usb thing, only thing i have in are keyboard, mouse,(non usb) and monitor. I haven't had any luck with windows cd either, just reads and skips to the next bootup. I need the stuff on the XP Sata drive so maybe i'll try reinstalling on the IDE.
 
no, although it seemed kinda odd that changing the motherboard would cause two versions of windows, on two different harddrives to both break. I'll give it a try though.



If this is not the exact same mobo (or at least very close) as before you need to reinstall.
 
no, although it seemed kinda odd that changing the motherboard would cause two versions of windows, on two different harddrives to both break. I'll give it a try though.

It really depends on the hardware that was used to install those versions of windows. Setup detects certain hardware and loads basic generic drivers that are compatible with the current hardware setup. As delemorte said, they have to be similar chipsets. Otherwise, no, its not odd that changing the motherboard would cause two windows installations to break.
 
Back
Top