will it work

[T-Frost]

Hey all new here..Had some parts lying around so decided to build a liquid setup for my comp..
http://www.lingenfelter.com/mm5/mer...e=L330010000&Category_Code=C66&Store_Code=LPE
Using this pump cause it's what i have..
http://www.amazon.com/gp/product/B0..._m=ATVPDKIKX0DER&pf_rd_r=14J7JV6835P9GBF827N1
this heater core for the same reason..

Putting it all in that case ..It's all empty now those were old pics..
This case will sit on top of my computer ,i have an Antec 300 .. So will be using the top 140 mm as a push for a push pull setup..

 

[T-Frost]

And it sits on this

So what do you think will it work..Got it all leak tested still need to get a Water block for my CPU..
Also need to run 2 wires out the back yet to my comp..Standard molex connector plugs into my comps PSU ,That way my comp turns on the cooler..Already have the relay wired to the PSU on the cooler.

 

[_r2h]

I'd put a fan directly on the rad also. Otherwise, should cool a cpu just fine.

 

[Tsumi]

Yeah, have a fan sit right on the radiator to maximize airflow through it. I would also say put a shroud on it, since you have room.

 

[T-Frost]

Well i have a shroud made for it and had it on, But i figured make the case airtight and i shouldn't need it..The shroud holds 1 140 mm fan ..The case has a 140 on top , 80 in rear and 60 in front..Still think i need the shroud?

 

[Tsumi]

Well, if it's as airtight as you claim, then theoretically, it won't make a difference. I would still put the shroud and 140 fan on, as it would give you improved static pressure and most likely airflow over the radiator.

 

[T-Frost]

Ok.. I'll use it..Might as well i have it..lol Maybe after i get the water block i'll do a temp comparison with and without the shroud..Thanx for the help..