Where did my GB's go?!?!

slightlyhuman

[H]ard|Gawd
Joined
Jan 20, 2003
Messages
1,186
Ok when I used my 160GB HD as a slave it showed it had 148 gigs free after a format. I asked someone where the other 12 was and they said it's the decimal vs binary conversions. Ok Well I decided to make my 160GB hdd my master drive so I set it to master and boot of cd ready to install winxp PRO.

After I press F8 and the drive info comes up asking which drive to install to, it only shows the 160GB hdd having 131ish gigs free, wtf? I even did a low level format with the boot cd and it still only shows 131GB's, where are the rest of the gigs at?



-noob
 
Your IDE controller may not natively support a drive that large. Try updating your BIOS and see if that helps.
 
Don't think that's it because the when it showed 148GB's when it was a slave, that sounded about right. But when switched to the master drive, only showing 131GB's in windows install, that was weird?

I've never updated a BIOS and can't believe I haven't when I have been around pc's as much as I have.

any other suggestions?

thx though dude
 
Your best bet is to slipstream SP2 into your XP CD and then install the OS on the 160 GB drive. Just when you think something's common knowledge, a new thread pops up proving you wrong....go figure.

Another method around this, is to partition the drive. I'm not sure why anyone would want a 160GB C drive, but to each his own.
 
Back
Top