what hose size?

[mrjayviper]

I'm sorta getting confused with all the information so I'm hoping you can help out.

if I get this barb,

does this mean I need to get a hose with an inner diameter of 1/2in?

thanks a lot

 

[SticKx911]

yup. 1/2 ID hose.

Just know that hose size really does not matter when doing a build. so use what you think will work best for your needs.

Personally I think 1/2" is too thick and hard to work with so I use 3/8" but 1/2" is more popular. To each their own.

 

[convexion]

I've been using 7/16" ID, 5/8" OD Masterkleer on 1/2" fittings for many years, the benefit being a virtually leak proof connection if installed properly. I used to use a heat gun to soften the tips of the tubing which made it easier to place on barbs. Since then I've switched to compression fittings, but still using the same tubing.

 

[JoeOnePack]

yup. 1/2 ID hose.

Just know that hose size really does not matter when doing a build. so use what you think will work best for your needs.

Personally I think 1/2" is too thick and hard to work with so I use 3/8" but 1/2" is more popular. To each their own.

Correctomondo.

 

[Tsumi]

Just make sure to get the tubes with the thick walls (e.g. 3/8" ID 5/8" OD, or 1/2" ID 3/4" OD). The extra thickness will help it not kink when making curves.

 

[JoeOnePack]

Just make sure to get the tubes with the thick walls (e.g. 3/8" ID 5/8" OD, or 1/2" ID 3/4" OD). The extra thickness will help it not kink when making curves.

If using a tight space, stick with the 3/8 x 5/8.