What do these beeps mean?

bgbird

n00b
Joined
Feb 25, 2010
Messages
3
ASUS P5B-E

Worked great 3 years
Today - get a normal post beep
30-45 seconds later 2 short beeps

nothing else happens after that

Monitor never get lit with any messages (normal or otherwise)

Took out all memory - when power up, immediately get 2 short beeps over and over
put in memory - and took out video - then got 3 short beeps over and over.

Anyone have any ideas?
 
From ASUS tech support

Dear Valued Customer

What you need to do is pull the motherboard out of the case and set it up on a non-conductive surface such as a phone book or the box the motherboard came in. Conect only the CPU, CPU fan, Case speaker (connects to Front panel connector near the power switch), Power switch and the Power Supply connections. Make sure you test outside of the case to eliminate all possibilities of ground.

Power the system up and if you get 1 long and 2 short beeps, the motherboard is telling you that there is no memory present. That is a good sign. Add one stick of memory and power the system on and if you get 1 long and 3 short beeps that is the Motherboard telling you that there is no graphics card present. Then add the graphics card and it should post.

If you don't get any beeps with just the CPU then your CPU or Motherboard is at fault. This could be because you need a specific bios revision for that particular CPU. Find the long skinny sticker with hyphenated numbers on the edge of the motherboard is towards the front of the case. The last 4 digits on that sticker are the bios revision that your motherboard shipped with. Now go to the CPU Support section of support.asus.com and compare your cpu. If the number on the sticker is less than the number on the support site then you will need a bios update. If not then either you CPU or Motherboard are bad.

If you get beeps at CPU but do not after adding a stick of memory. That means you may have a bad stick of memory. Try all the slots with all the memory 1 stick/slot at a time.

If you get to adding the VGA card and it still does not post after adding it then it may be your graphics card that is at fault.

Also Please check on support.asus.com for our Power Supply Wattage calculator to make sure you have a power supply that can power all your components.

If you need any further assistance please contact us at 812-282-2787 opt3, followed by opt3 for additional troubleshooting.

Regards,

Daniel Klingman
Asus Support Team
 
Tried everything as recommended.
Get one normal beep (sounds like a normal post)
30-45 seconds later, get 2 short beeps

I also see some disk activity before post
and some disk activity right before the 2 short beeps

During this whole process, the monitor never displays any information

At this point - do I buy a new motherboard - or a new video card?
 
Usually that sequence indicates bad memory...at least for stuff I've had. Try new ram. Or one stick at a time.
 
i would start with this.
reset cmos
disconnect everything (fans, hdds, all pci cards, rom drives, ram)

put one stick of ram in and the gpu
see what happens.
 
Last edited:
Did you remove the mobo like sgrinavi said? See if you get the beeps in order.
 
Followed the directions as stated. Still got one normal beep (post) then after about 45 seconds 2 beeps. When I removed the motherboard and put it on the bench, I used a spare monitor in the shop - which was analog - not digital. Interesting enough, the monitor started to display boot information - although there were a lot of wierd artifacts. At this point, I went out and bought a new video card - all seems to work well now except win7 wake up ( dual monitors - Nvidia). I think that I'll start a new post for that and describe it in more detail - but wanted to close out the information for this problem here...

Thanks to all for their input!
 
Back
Top