So I'm sitting here at work, doing my work stuff, and I started thinking about hard drives (I recently had one fail so it was on my mind)...
I've done a lot of reading recently on hard drives but it occurs to me that I have not read WHAT causes the heat in a hard drive. Thinking about it my self I can only come up with a few sources, some of them very minimal:
I dont believe there are any other sources of real heat generation inside that little box. The last two are probably minimal at worst, but then again, I dont know!
So my question to you all is:
What causes hard drives to heat up so much?
My personal opinion is that the air/platter friction is the main source. Assuming, obviously, that there isnt a vaccuum inside the case. Which leads me to this, even a relativly mild vaccum in the case should do two things, reduce platter friction and thus heat generation, and reduce the amount of torque required to keep the disk spinning, reducing heat again and also energy required to operate.
What are you thoughts?
I've done a lot of reading recently on hard drives but it occurs to me that I have not read WHAT causes the heat in a hard drive. Thinking about it my self I can only come up with a few sources, some of them very minimal:
- Air to Platter Friction
- Electric motor current
- Electric motor friction
- Read head stepper motor thing
- External on board circuitry heat
- Internal circuitry (if there is any?)
- Read head (not friction, but the electrical energy through the traces)
I dont believe there are any other sources of real heat generation inside that little box. The last two are probably minimal at worst, but then again, I dont know!
So my question to you all is:
What causes hard drives to heat up so much?
My personal opinion is that the air/platter friction is the main source. Assuming, obviously, that there isnt a vaccuum inside the case. Which leads me to this, even a relativly mild vaccum in the case should do two things, reduce platter friction and thus heat generation, and reduce the amount of torque required to keep the disk spinning, reducing heat again and also energy required to operate.
What are you thoughts?