voltage settings and stability help QX6700

Joined
Dec 12, 2004
Messages
584
I have QX6700 CPU with Zalman 9700 cooler
Evga 680i SLI A1 mobo
2 gigs Corsair Dominator running at 1120 mhz
Win XP Pro
Idle temps at 47c max load at 62c
I ran memtest and no errors at all for 6 hours.

My CPU is clock at 3.2ghz from 2.66 stock , multiplier is X10 FSB clock 320mhz
Not sure what volts to be in at this speed any one?
I have mine set at 1.34v
ram is at 2.2v which is manufacture default spec.
FSB volts at 1.40
nForce volts at 1.52
I run stable at encoding videos and Super pi in all test. In Orthos when i get to smaller FFT like 32, after 5 min my computer freez, can't alt tab or ctr-alt-del. I had to hit reset to restart the machine. I ran 1024fft and it was running fine. I run prime for 2 hours and it did fine.
Whats going on, Im i setting something wrong.
 
Just for grins - set all of your voltages to AUTO except the Memory and CPU. Set the CPU to about 1.45v and leave the memory at the recommended voltage from Corsair. My EVGA undervolts quite a bit, so make sure your "Actual Voltage" as indicated in the System Monitor is around 1.4v. Reboot a couple of times after making those changes and enter the bios to verify. Run the newer version of Prime95 with worker threads in Blend Mode and see how things go. Use Coretemp to monitor your temperatures and keep them below 70C. If it stabilizes, then you know your CPU most likely needed more voltage. Run Prime95 for 24 hours - if it passes, lower the voltage a bit, and retest. Keep going until it fails and then bump the voltage back up to the last point where it passed testing. I'd recommend going a hair above that for piece of mind and to account for additional voltage draw while gaming, or adding other devices. My X3220 Xeon Quad is perfectly stable at 3.2GHZ using 1.325 Vcore. I've been running Prime95 in blend for over 48 hours so far. Large FFT's stress the CPU less than Small FFT's. I see a 10C difference between the two on my quad core - it's pretty drastic.

One other thing you could do is lower the Multi to 8, set your FSB to 1600 and try to dial in your memory speed to match that of the factory rating on your ram. My system run 8x400 and memory at DDR800 Linked/Synced without any issues. 48 hours of Prime95 so far, I'll let it go 96 hours before calling it good.
 
yea I use the latest Win DVD creator, encode a full movie from avi file to a DVD format.
Also run Super Pi all test past. Also run DVD shrink of a complete movie.
I set all volts to auto now, CPU I bump it up to 1.35v. When I get the chance I will run Orthos, My system hang, on my custom setting with FFT 32 and big amount of ram. I don't have the time to run this orthos for many hours yet.
To day is darn hot, and my apartment room temp is 76f or 77f with AC on. Now my load temp in Core temp shows reading of a steady 77c at load on Orthos that I just start 15 minutes ago. I notice it only uses 2 cores.
 
Back
Top