- Joined
- Aug 4, 2004
- Messages
- 2,658
Just wanting to toss this out there and make sure I understand the upgrade steps right. My current View environment is running on a single Dell R710 with 48GB ram and 2 6-core processors. It was orginally built as a test enviroment and runs about 25 desktops. The workstations are split between training systems (clinical application that requires static IPs, so I had the network team reserve DHCP address by the virtual MAC addresses of the systems) and virtual desktops for our service desk running WinXP for some software that doesn't run on Windows 7 yet.
I'll be adding an additional host to the cluster as well as increasing the memory to 96 GB on both hosts. Currently we are only using vCenter, Composer, and View Connection Server. We don't currently allow access to the View environment from outside the network.
From reading up, my understanding is that I should do the following.
1) Install ESXi 5 on the new host (another Dell R710) and attach it to the SAN
2) Upgrade vCenter and Composer (running on the same virtual machine in our production ESXi cluster)
3) Upgrade the View Connection Server
4) Add the new host to the cluster
5) Migrate the VMs to the new host
6) Remove the old host from the cluster
7) Shut down the old host, add memory, install ESXi, configure SAN access
8) Add the upgraded host to the cluster
The good part is since it is only training and limited use by the service desk, downtime shouldn't be an issue. Bad news is I need to make sure that the virtual linked-clone workstations stay configured as they are (specifically MAC addresses).
Am I missing anything? Got something out of order?
I'll be adding an additional host to the cluster as well as increasing the memory to 96 GB on both hosts. Currently we are only using vCenter, Composer, and View Connection Server. We don't currently allow access to the View environment from outside the network.
From reading up, my understanding is that I should do the following.
1) Install ESXi 5 on the new host (another Dell R710) and attach it to the SAN
2) Upgrade vCenter and Composer (running on the same virtual machine in our production ESXi cluster)
3) Upgrade the View Connection Server
4) Add the new host to the cluster
5) Migrate the VMs to the new host
6) Remove the old host from the cluster
7) Shut down the old host, add memory, install ESXi, configure SAN access
8) Add the upgraded host to the cluster
The good part is since it is only training and limited use by the service desk, downtime shouldn't be an issue. Bad news is I need to make sure that the virtual linked-clone workstations stay configured as they are (specifically MAC addresses).
Am I missing anything? Got something out of order?