Video Card Latch replacement?

Jsalpha2

Limp Gawd
Joined
Dec 19, 2011
Messages
209
I have a motherboard with the latch to hold the video card in place broken off and missing. Working fine with on-board video. If I put in a video card without the latch, will there be problems? Can I put on a new latch? The motherboard is an Asus H87M-Plus (I5-1150). I usually use short single fan video cards. Best similar motherboard under $100?
Thanks
 
It looks like maybe if you found a replacement latch it could be replaced. However I feel that as long as you are careful and not moving the machine around constantly the card would be just fine with the screw holding it to the case.
 
No latch is no problem as long as you insert the card fully into the board and screw the card to the case.
 
Tie off the end of the card with dental floss or a piece of insulated wire fastened to case.
 
Anyone remember ISA slots? lol

ISA slots really never had a problem with cards coming out unless you used huge full length cards.

More of a problem were VLB cards with both the ISA connector on the front of the card and the VLB connector on the back of the card, thermal stress could eventually work the card out of either slot and cause problems.
 
Tie off the end of the card with dental floss or a piece of insulated wire fastened to case.

say whahhhht........where in the world did this idea come from ? Talk about ghetto mods, geezy o wheezy so cheezy :D

I know lots of pc enthusiasts, and I'm fairly sure not a single one of them would want to use dental floss or wire anywhere inside their rigs....
 
say whahhhht........where in the world did this idea come from ? Talk about ghetto mods, geezy o wheezy so cheezy :D

I know lots of pc enthusiasts, and I'm fairly sure not a single one of them would want to use dental floss or wire anywhere inside their rigs....
I've never met an enthusiast with a broken latch for a PCIe slot so......................... He wanted a ghetto mod and I gave him one. You don't have to take the advice.
 
ISA slots really never had a problem with cards coming out unless you used huge full length cards.

More of a problem were VLB cards with both the ISA connector on the front of the card and the VLB connector on the back of the card, thermal stress could eventually work the card out of either slot and cause problems.

Haha remember EISA? THose were deep pins.
 
Super glue anyone? har har har....On serious note, put it in and put screws to fasten the card to the case. Problem solved!
 
I'm surprised mb companies don't sell these latches for $5.00 or so, they could
make money off this...
I'd buy one... :)
 
Haha remember EISA? THose were deep pins.

I've only ever encountered one EISA system and yes, those sockets are definitely deep and strange looking. They looked similar to an AGP connector except twice the length.
 
Grab a pack of these:
GTTP_Feature_04_l.jpg

Then thread into the GPU and somewhere on the case for support. My latch is not broken however I don't care to see the sag.

20160903_152423.jpg
 
Back
Top