Very Weird

PornFlake

Limp Gawd
Joined
Feb 24, 2005
Messages
270
Got a buddy who has to pull the power switch jumper on the MB every time the system looses power to be able to boot the system.

If he pulls the power cord out of the wall, he has to pull and replace the power switch jumper on the MB before system will boot.

Any thoughts on this one????

-Flake
 
There's no power switch jumper. You mean the CMOS reset jumper? That'd make more sense. Try replacing the BIOS battery, maybe. Otherwise it sounds like there's a problem with the motherboard or PSU.
 
No, I mean if he pulls the power plug from the wall or the system looses power he has to pull the cover on the tower and pull the power switch jumper off the motherboard re-attach it and then when he pushes the power switch on the case the system will power up.

He can restart the system all he wants via the OS. The problems comes into play when power is removed from the system and then reapplied.

-Flake
 
"Power switch jumper" being the 24-pin main power connector or what? Because I still have no idea what you're talking about. There's honestly no such thing.
 
No, the power switch pin on the motherboard for the power switch on the case.

-Flake
 
No, the power switch pin on the motherboard for the power switch on the case.

-Flake

Case switch is broken, possibly. It works fine if you use a paperclip to short the pins instead? Unplug it from the board, go through the usual scenario that ends up with having to unplug it and plug it back in, see if it continues to work past that point by just shorting the pins. If so, the case switch is getting 'stuck' and needs to be replaced. Sadly that's easier said than done.
 
There are several causes for this.

In a nutshell, what is happening is the switch is staying "on" instead of only being on when the switch is pushed.

this can be caused by a faulty switch, a switch that has been wired wrong, or the wrong kind of switch being used.

If this is a Compaq/HP/Sony/Dell case, then try simply switching the polarity of the jumper. I'veseen harnesses from all 3 company's cases that had a common ground wire attaching both the power and reset switches together. If you get the polarity wrong on either one, the switch will ground out through the other switch's ground wire.

Kinda hard to explain, but just try switching the polarity of the switch's jumpers and see what happens.
 
Back
Top