Using GA-8INXP RAID Ultra 133 solo?

afropuff

Limp Gawd
Joined
Oct 1, 2002
Messages
448
Hello all,

I am having some problems. I am trying to use my Mobo's IDE 3 port, which supports RAID to use just 1 hard drive in ATA 133 mode. I currently have the HD installed on IDE 2, and it is running at ATA 100....I can install the drive there, and it boots up & detects the drive on IDE 3, but once in trys to load windows i get a BSOD real fast then a restart...

Any idea what is going on??

thnx

-fro
 
did you just move the drive from a standard IDE channel to the RAID channel? if that's the case, windows is gonna have a helluva time trying to set itself to boot from a device that wasn't originally specified as a boot device-- i've had the same issues before. mine wouldn't even bluescreen, though, it'd just restart

i believe if you install windows, specify the driver for the promise controller during the installation, then you *might* be able to run the drive in ata/133 on that single channel, but i'm not 100% sure that would work.
 
Back
Top