USB mouse doesn't work on boot

Slartibartfast

Supreme [H]ardness
Joined
Sep 25, 2004
Messages
7,280
I am using a Razer Copperhead with Windows XP x64. When I boot the system, about 75% of the time the mouse does not work. It lights up fine, and windows does not give me a warning about no mouse. However, when I move the mouse the cursor is unresponsive. This is always fixed by unplugging the mouse and plugging it back in.

However, it does not matter which USB port I use initially or which port I plug it back in to. It can even be the same port. This happens whether I am using the 32-bit drivers, the 64-bit drivers, or no drivers at all. I never had this issue with my old PS/2 mouse. I don't have any other USB mice to test this with and would rather not buy one just for the sake of trying to diagnose this, unless I have to.
 
USB shouldn't work until windows is booted up so i can be recognized. But once you see the windows logo then it should all be working fine.

If its not working in windows after a boot. Check to make sure the usb ports are connected properly if your using ones that are not directly wired to the MB.
 
I have seen this before with certain main boards. Try switching the USB legacy device settings in the BIOS. Also updating you BIOS my fix this.
 
USB shouldn't work until windows is booted up so i can be recognized. But once you see the windows logo then it should all be working fine.

If its not working in windows after a boot. Check to make sure the usb ports are connected properly if your using ones that are not directly wired to the MB.

Yeah, it's not working in Windows after boot. I am using USB ports wired directly to the MB, doesn't matter which of the 4 I use.

I have seen this before with certain main boards. Try switching the USB legacy device settings in the BIOS. Also updating you BIOS my fix this.

Yeah, I've screwed around with every USB setting in the BIOS I can find. I think there is a newer BIOS out there than what I have, I will have to double-check.
 
I had that happen with one of my old motherboards. Turns out I had to reinstall my USB drivers. Try that and see if it helps.
 
Flashing the BIOS didn't help, and it doesn't matter if USB legacy support is enabled or disabled.
 
I replaced the Razer Copperhead with a Logitech MX400. Even using it through USB, the MX400 is perfectly fine. I guess it was the Copperhead's fault.
 
Back
Top