Tubing Size Matter for GPU Full Coverage?

kadozer

[H]ard|Gawd
Joined
Jun 29, 2007
Messages
1,881
I'm not new to watercooling however, I never used a GPU loop before. I plan to get the EK full coverage block for the 4870x2 and most of the pics I've seen of wc setups have smaller diameter tubing as opposed to their cpu loops.

Wondering if 1/2" 3/4od is ok for a GPU loop. Or do I need to go smaller? Also are the threading spacers necessary for the GPU block Inlet/outlets?

Will be going with a 1x120mm radiator and a Laing 350 10-12 watt Alphacool acrylic top pump.
 
Totally doesn't matter.

Use whatever you like the looks of :)

However, a 4870X2 with a single 120mm radiator will have a very high temperature delta... From what I've seen, that card at load has a TDP of around 280w... Easily saturating the 150w heat dump capability of a single 120mm radiator.
 
Size in this case shouldn't matter. Running 1/2" should be fine. I doubt that running smaller 3/8" using your Laing pump will make much of a difference, its just a matter of how much cooling your 120x1 radiator can provide. I know some people that run separate loops like to run GPU with smaller hosing, but I think its a matter of neatness more than an actual functional difference, especially in mid tower cases.
 
One reason to go with smaller diameter is that 3/8 is easier to route and hard to collapse. I'm not familiar with the 350, but try to keep 1.5GPM (or more) pushing through your loop and you'll be okay.
 
Back
Top