Troubleshooting after replaced Power Supply

jreffy

Limp Gawd
Joined
Jul 25, 2006
Messages
300
Working with my girlfriend's father's PC, so I am not intricately familiar with it's setup. I'll come back with more details after I collect them, just wanted to make a generic post to see if it was some simply solution.

INITIAL PROBLEM: The PC was not powering up, only the front LED would come on, no fans, no hard drive spinning, nothing. I replaced the power supply and everything seems to power on just fine.

CURRENT PROBLEM: Now the PC starts the booting process. BIOS comes up, everything seems to be working fine, however there are some issues.

1) There's a constant regulary beeping noise as long as the PC is running (beep, pause, beep, pause, beep, pause, etc.). I haven't tried counting them yet to see if there is a longer pause, but I will.

2)During the booting process a few things happen that I've never seen. It does what appears to be some kind of IDE scan? Also displays an option to enter the RAID setup menu, so I assume the PC has a RAID setup (2 HDDs). When Primary Master is displayed it simply says "None". Furthermore, later on, it displays,

HDD 1: not detected
HDD 2: not detected
HDD 3: not detected
HDD 4: not detected.

3) The Windows loading screen comes up and shortly after the PC simply shuts down. I was able to boot up into safe-mode once, but never again after that.

Any initial ideas simply based on the beeping or other issues when power supplies are replaced?
 
well i can tell yu off the bat that when you took the PSU out, your BIOS settigns were probably lost, meaning the CMOS battery in the Motherboard might be dead. this is why your hard drives might be detected, as a BIOS setting might have been changed, and thats why its not booting now.

also, as for the beeping, make sure EVERYTHING IN THE PC is properly and securly connected... this happened on my sisters DFI Nforce 4 Ultra board. something was connected properly (i can't remember what, it was either a fan or a PSU plug, or maybe the sound/graphics card, something). double check that all the expansion cards are secured into the slots. make sure all the plugs are in all the way, and lastly make sure nothing smells bad in there, just incase.
 
The computer IS booting. It's going through BIOS and going right to the Windows Loading screen. That's where all the power cuts out and the PC shuts down. Throughout the booting process though it is putting out that repetitive beep.

Would a reformat and reinstall of Windows help? Obviously my last resort.

Perhaps if the BIOS settings were lost, and I'm positive this PC is setup with a RAID, do I need to setup the BIOS to detect it in some special way? Then again, would I even be getting the Windows loading screen if it wasn't detecting a hard drive?
 
heh that is wierd...

it could be that even though its booting off the drive, its not detecting the RAID setup, and windows stops. it could also be a blue screen.
when you start the computer, tap F8 repeatedly and when the boot menu comes up choose "disable automatic restart......" see if you get a blue screen.
 
Back
Top