Troubleshoot this one batman

RooK

[H]ard|Gawd
Joined
Aug 19, 2001
Messages
1,108
Happy holidays and new years and all that jazz! Next realize that we are dealing with "sort of" an old mobo - its one of those RD-Ram suckers.

First off, specs that matter....
Abit TH7-II
P4 1.5
512 megs PC800 (RDRAM)

Anyways, I'm having a problem. I got a new mobo, and took out the motherboard to put into another case. So I take it out, install it as I have a million times before with other motherboards as I build computer quite frequently, and the following happens...

Nothing.

The light on the board lights up to indicate power is connected, however, it will not power on. I've tried to reseat everything multiple times and tried different power supplies.

I've even gone as far as putting the old mobo back into the case it was originally in and it just has the same results. I've checked the board over for any sort of burn marks or anything of that matter, and I cannot find anything. I've had this board for a couple years and I know it quite well, and well.... i'm just confused as to what could be wrong here.

Its getting power, obviously, from the indication of one of the motherboard lights, but it will not power on via front switch or the button on the board itself. I've tried clearing the CMOS and reseating everything and disconnecting everything possible from the motherboard just to get it to power up. I can't figure out whats going on here - there was no smoke let out and not even the power supply will spin up but that little light never flickers - unless I unplug it of course.

Thanks for any help possible.

Jess
 
Hmm

1st off, make sure nothing is grounded. Make sure nothing on the mobo is touching the mobo tray. 2nd, make sure you have the power button connected to the right pins.
 
yup

checked that...

is it possible a transitor burnt out and its impossible to detect it without extensive meter reading?
 
I found something

it looks like a little burnt spot on the upper right corner... it corresponds with two transistors which say....

1000uf
10V

I'm guessing this is the problem as those sound like some serious juicers... can I bypass these just by bypassing them or should I just clip them off and head to radio shack?

it doesn't look "really" burnt... just looks like there has been some residue of some sort on there... it scratches off, but i'm guessing those transistors are fried
 
Abit motherboard? Bad caps? Never.

You're a proud owner of one of the motherboards that had bad capacitors. Unfortunately, it chose to stop working once you moved the mobo. You can attempt to replace them but it isn't easy.
 
On the other hand it is cheap, and you've got nothing to lose. They are capacitors, and there's nothing special about them. Any electronics hobbyist will stock them. Don't clip them off (desolder if you can), and make a note on which way round the pins go (that's very important). It will be marked.
 
ok, this is just odd....

in a sort of haze, I flipped out the bios chip right before the guy said "make sure your board isn't grounded" so I made sure of that right after I plugged the bios chip back in, and what do you know...

works... Now my only problem is a hard drive that is now sounding like a yetti. Needless to say it won't boot - well, it did until I started using sectors that are appearently bad.
 
Back
Top