Tighter memory timings

Burner27

Supreme [H]ardness
2FA
Joined
Oct 23, 2000
Messages
6,868
I am in need of opinions regarding memory tweaks.

I see some of the timings that people have been using with great success, but what I want to know is:

Other than using benchmarking utilities (i.e SiSoft Sandra), do you "see" or "feel" a difference in the way your machine runs with timings set at SPD vs manually setting timings to like 2-2-2-5?

I would be very interested to hear from other people if games play faster or apps running faster with tighter memory timings.

Thanks.
 
Mine are set at 2-2-2-5 at default, and yes I do notice a difference when I change them. I can overclock higher with looser settings, but games seem to run better with the lower settings and smaller overclock.
 
With Intel systems especially memory bandwidth is more important than you might think. That is just the way thier architecture works. The P4 needs memory bandwidth and speed.
 
I read an article off Hocp sight talking about mem timmings and bench marks. Funny thing was that some times higher meant better marks just an FYI
 
Originally posted by BackStabber
I read an article off Hocp sight talking about mem timmings and bench marks. Funny thing was that some times higher meant better marks just an FYI

Could you post the link?
 
So I can run my Corsair PC3500 modules at 2-2-2-5 with PAT and TURBO enabled with no issues. Ran memtest86 for 5 hours without so much as a hiccup and I ran Prime 95 for 8 hours and no hiccup either. Would it be safe to assume that my memory rated for PC3500(DDR433) at CAS2 should be fine at DDR400 speeds @ CAS2?

The actual model number is CMX512-3500C2 the "XMS" series.
 
If they're rated at DDR433 for CAS2, then yes, they'd operate the same timings at DDR400. It's when you run the RAM past DDR433 that you would have to drop the timings.

However, for an Intel system, memory bandwidth is more important than tight timings.
 
Hey burner, this is in reply to your message.

Sorry I wasn't around to answer it, too busy playing Desert Combat, I mean, "doing schoolwork." ;)

Anyways, for RAM, if you set it to Turbo in the BIOS settings, it will try to set the RAM to very aggressive timings. It's probably just the same as manually setting your timings to 2-2-2-5, but it doesn't hurt when you're at stock speeds.

However, when you start overclocking, you'll have to change it from Turbo to Auto and change some other settings around because at higher frequencies, you might not be able to keep such tight timings. That's how it is with my Mushkin Level IIs. They can't operate at DDR433 in 2-2-2-5, only 2-3-2-5 at DDR433, so I dropped Turbo mode.

Hope that answers your questions. If you have any other questions/comments, just ask the forums or shoot me a line.

Later.
 
Back
Top