The device, \Device\Harddisk0\DR0, has a bad block.

theinv

Limp Gawd
Joined
Apr 17, 2008
Messages
216
In the past few days, I got this error "The device, \Device\Harddisk0\DR0, has a bad block." in the event viewer.

I believe this is for my 8 disk RAID6 array. The weird thing is if I go to the RAID controller's card's management interface, I don't see it report any bad disks. I am using Areca 1680X.

Is this a serious issue? What should I do to fix it?
 
Can you check the SMART information of that particular drive through the Areca utility? I know the areca-cli utility under Linux/BSD; but i don't know their utility under Windows. It should allow you to see the SMART information. Check for C5 Current Pending Sector; if its not zero you should fix it soon!
 
Can I use windows 7's "tools->error checking' to check disk error on raid arrays?
 
I don't see the place that shows the SMART info.

Can you check the SMART information of that particular drive through the Areca utility? I know the areca-cli utility under Linux/BSD; but i don't know their utility under Windows. It should allow you to see the SMART information. Check for C5 Current Pending Sector; if its not zero you should fix it soon!
 
Back
Top