• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

The 12V Rail Question!

X

XSKSTEVEXX

n00b
Joined
Sep 26, 2005
Messages
48
I could use some help with a power supply. I have been shopping around and I am getting a bit confused on which would be best for my setup.

Just to have room for future parts I am leaning toward a 700-750W PSU, but what about the 12v rails on these? some manufacturers have a huge single 12V rail ( 60A + ) while others may have 4 or 5 18-20A rails. What is the benefit? What should I go with for an SLI setup?
 
That is getting much too low. + or - 5% is within ATX spec however the higher the better as long as it is close to 12v. Perhaps the software is reading wrong? Never trust software readings if at all possible. Get yourself a Digital multimeter and test for yourself for a more accurate reading.
 
hehe yea, no clue what happened, perhaps I read the original thread but clicked on the above/below it to respond. sorry!
 
You must log in or register to reply here.
Back
Top