Tech Difficulties... Plz help!

Joined
Jan 17, 2007
Messages
624
Ok this is really odd. I just installed a new desk, so all i did was move the computer. Now that I reconnected everything, the monitor refuses to come out of standby when the computer is started up and the keyboard won't come on. Everything else works fine. Tried both a different USB port and using the PS/2 port via adapter on the keyboard. No luck any help PLEASE!
 
I've tested the keyboard on another computer. It works fine. Also I didn't change any components in the computer just disconnected everything and reconnected.
 
Something may have come loose inside when you moved it. Or, it could be a dead PSU. I'd disconnect/reconnect everything inside and try again. If it still won't work, try another PSU. Report back for more suggestions.
 
Well the computer itself is turning on, the LED lights, and i can hear the hard drive spin up. Everything else is working normally, including other USB things like the mouse. Just the monitor and keyboard. It's really odd... I don't have another PSU handy anymore, this is my backup one...
 
do you hear the post beeps? unplug all the drives (and whatever else isn't essential for POST) and see if that changes anything. it sounds like you might have damaged the connectors... make sure none of the pins are bent (though, this shouldn't cause a totally black screen).

edit:
http://hardforum.com/showthread.php?t=1160917

so its just the monitor stuck in standby? did you try another monitor?
 
I didn't have much time to toy with it last night, but I'll listen for the beeps. Should there be a beep or is that bad? I don't have another monitor to try but I'll try and connect this monitor up to my laptop and try and do a clone screen and see if it works. Yea it's just my monitor stuck in standby. I start up the computer and it turns green for a second then goes right into standby (The monitor)
 
k found that the power supply is too small for all the stuff I got in the computer. Thanks for all the help!
 
Heh... I had a feeling... anyhow... What PSU do you have and what are all the components inside your system? I hope you don't replace it with a bad PSU. Pick a good one, and read the PSU subforum guide, as well as jonnyguru.com's recommendations.
 
Actually I found out this didn't work. It was working fine until I unplugged the mouse (USB mouse connected to the PS/2 port via adapter) and replugged it because the wire was wrapped around stuff. The problem started again. I tried unplugging more of the lights but nothing changed. I also tried changing out the graphics card and the hard drive. I tried taking out the ram but it beeped wildly at me, but it does that as I tried removing 2 of the 4 ram sticks before (RDRAM needs to be in pairs). I did take out the X-Fi sound card and it started working, but didn't boot up all the way. So I left the card out and shut off the computer and started it again with the same problem, so I am assuming its not the sound card. Any other ideas? This is really driving me insane! Thanks for any help. Also if I unplug the keyboard and mouse I don't hear any beeps.
 
inspect your connectors, and the rear i/o panel, to make sure nothing was damaged.
 
Back
Top