Switching from gui to console.

[mobiux]

How do i go about switching an existing gui install to console install without losing the work that's been done?

 

[Tigerbiten]

Delete the GUI exe and install the console.exe.
Make a shortcut and add the -configonly switch.
Start from shortcut and config it.
If it works right it should show you your username, ect, etc from the last install you did.
Restart in required mode with the switches -forceasm & -advmethods as needed.
Hopefully that should work.

Better still just wait untill you finish a Work Unit and are on the first couple of frames of a new one.
That way if it goes wrong you dont loose that much work.

Luck.........