Swapping Motherboards - retaining OS

ALpHaMoNk

Weaksauce
Joined
Oct 12, 2010
Messages
108
I recently swapped out a dying mobo on my home server. I upgraded the cpu, and ram at the sime time. I hard to reinstall windows 2008 r2 and reconfigure the server ( don't want to do that again.)
problem!
after running the server with no issues for months I realized that stupid me did not enable the raid in the bios.
Now when i go to enable it windows blue screens (as expended) when i reset and disable the bios all is good again.

is there any way for me to re-enable the raid on the mobo and retain windows? I know the issue is driver related.

pics and specs of build upgrade
 
Give it a minute and I could find the registry setting.

Basically there is a registry setting to indicate if drivers have been loaded for IDE/AHCI/RAID. If you reset that back to 0, reboot the machine and enter the BIOS, change to the new drive setting and then let Windows start as normal it will run the detection code and install the correct drivers instead of blue screening when it tries to use the already installed drivers.
 
Ok, I think this is it. Scroll down to the 'fix it myself' to see the registry keys that need to be reset to 0. I think you only need to reset one (but which one depends on what mode you are), but Microsoft seems to think it's ok to just reset them all and let Windows sort it out when you reboot.

http://support.microsoft.com/kb/922976

And one other key:

HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\atapi

I think you only need to reset the Start value to 0 for this one if you are changing from RAID back to IDE/AHCI, since in RAID mode this driver is unused and gets put to sleep.
 
David thanks for the help I will give it a try and report back on how things go.......basically it should still boot to windows and windows will look for the driver upon boot?
 
RAID and AHCI drivers are disabled by default on Windows installation unless the drives are already being in run in RAID/AHCI mode.

Just google enable AHCI drivers for your Windows installation. It's a very common problem people run into.
 
Yes, it will rerun the same detection it does during setup to determine if the driver should be enabled. After it makes any changes Windows will be rebooted automatically.

So the steps are:

Close all programs

Go into the registry and mark the relevent drivers start mode as 0 (meaning 'I don't know, lets check')

Shut down Windows

Go into the BIOS (before starting Windows again) and change the SATA mode from IDE or ADCI to RAID

Start up Windows. Windows will run its detection code and see that the SATA controller is running in RAID mode and turn on the right drivers. It will then reboot for the changes to take effect.
 
thanks all....the steps everyone provided seemed to do the trick.you guys really saved my neck on this one.


thanks again.
 
Back
Top